If you have any questions feel free to drop me a line.

These procedures are if you are ordering any of the following keys B96PT, B97PT, B98PT B99PT B100PT Originate New Master Key.

1. After key is properly cut, Insert new key into ignition cylinder and turn it to the (ON) or (RUN) position. The security light on the dash will illuminate and stay on for ten minutes.

2. When the security light goes out, you have one minute to start the next step. Turn the ignition to the off position and then back to the (ON) or (RUN) position. The security light on the dash will illuminate and stay on for ten more minutes.

3. When the security light goes out, you have one minute to start the next step. Turn the ignition to the off position and then back to the (ON) or (RUN) position. The security light on the dash will illuminate and stay on for ten more minutes.

4. When the security light has gone off for the third time the key has been programmed into the vehicles computer and will operate the car.

***Note the above procedure replaces ALL previous electronic key codes, and is the only programmed key for the vehicles computer***

These procedures are if you are ordering any of the following keys B96PT, B97PT, B98PT B99PT B100PT Adding Duplicate Keys

1. Insert an existing key into the ignition cylinder.

2. Turn the ignition to the on or run position and then back off.

3. Remove key and insert properly cut new key within 15 seconds and turn it to the on or run position

4. The security lighy will illuminate for two seconds to indicate success in programming the new key.

BACK HOME

Back to the key store.

Any keys ordered under the following numbers would allow your Locksmith to electronically clone your existing keys or any from above

B96PT5, B97PT5, B98PT5, B99PT5, B100PT